total noob to homebrewing so excuse the dumb question.
20% BB, 1% BA, MCT oil. 60mg/ml superdrol. Nothing special. I stirred and heated my solution for around 30 minutes and there are many powder “rocks” refusing to dissolve.
Question: Can i assume my raws are dirty as hell OR is that normal and i can just draw that stuff, push it through a 0.22 um syringe filter and be good? I mean even if i assume the powders purity sucks, a good PVDF syringe filter should make that awful purity, void, no?
EDIT: Slightly increase the BB by a couple percent and that was enough to dissolve 60mg/ml.
EDIT: Needed 30% BB for 100mg/ml, seems to crystialize in tiny amounts.
EDIT: 100mg/ml, 0.2ml injection stinged a little bit. No PIP, injected into my glute with a 8mm needle.
20% BB, 1% BA, MCT oil. 60mg/ml superdrol. Nothing special. I stirred and heated my solution for around 30 minutes and there are many powder “rocks” refusing to dissolve.
Question: Can i assume my raws are dirty as hell OR is that normal and i can just draw that stuff, push it through a 0.22 um syringe filter and be good? I mean even if i assume the powders purity sucks, a good PVDF syringe filter should make that awful purity, void, no?
EDIT: Slightly increase the BB by a couple percent and that was enough to dissolve 60mg/ml.
EDIT: Needed 30% BB for 100mg/ml, seems to crystialize in tiny amounts.
EDIT: 100mg/ml, 0.2ml injection stinged a little bit. No PIP, injected into my glute with a 8mm needle.
Last edited: