No ester compounds.

[hypeofbeauty1]

I’ll break it down how I’ve used them in the past and you can go off that or just reference that up to you brotha. Anytime I’ve used test suspension I’ve always made sure it’s oil based no ester and not water based. The water based versions clog to easily and can hurt like a mofo. #1 key is to not rely on the TNE as your base. Make sure you have a king water test like eth or cyp or sust your running to keep tour blood levels as steady as possible. Then what I would do is just use the TNE pre workout . But here’s a key part I hope you really take home and remeber. Even though there’s no ester attachment it doesn’t kick in right away like you’ll see so many people claim and there’s more than enough science and studies to show this. Inject it about 1.5-2 hours before
You go to the gym. That way it’s taking effect and climbing during your workout and you can utilize it for what it’s supposed to be for. Another tip for PIP related stuff. Everyone is different and every company varies on how well they filter and brew etc. i always start out in my glute or shoulder and start with just a half ml jus to see how you handle the pip if any. Stay the hell away from your legs. Some people claim they’ve never had problems and others complete opposite. I’ve used legs for years and years but my absolute Worst most part losing shots came from my legs and I still can’t tell you why. Nothing went wrong nothing was new or different. I think cuz my quads are jus so much muscle and lean and vascular AF too jus made a Recipe for disaster. Cuz after those bad injects I was limping hard for a full week

I used my legs for year and just recently switched to glutes. So much scar tissue in my legs made it near impossible to have a successful injection. That and many e.r.visits for the infections it caused shooting into thay scar tissue. I was even in the hospital for a week one time although I think they just wanted to BAM my insurance.

 

[machb]

Heat the water based test suspension before drawing, this will significantly reduce PIP. If you think about it, crystalline test base is dissolved/suspended in solvent carrier and a certain amount will drop out of solution. Same with higher concentrate oils will crash in colder temps, the solution is to heat them. Use a 23g needle to fill syringe and a 26ga to inject. Never had an issue with Synergy Suspension with 26ga needles.