I started homebrewing a couple months ago and it has been great. I've brewed Test C, Test P, and Tren Ace with great results.
I did a 250mg/mL brew today of Test E and ran into some issues filtering. I use a glass vacuum filter with a .22um filter in it and a hand pump. It's worked really good for me up until today.
Today when I got the filter setup under pressure the brew did not want to pass through that filter. I pumped the pressure up to higher than normal and just got dribbles into the beaker. After of about 5mL it completely stopped.
Just to add, I can confirm that the test did fully dissolved and my brew was clear before added my carrier oil. I also did heat the brew to about 140 before filtering using a magnetic hotplate/ mixer.
Recipe
Test E - 25g
BA - 2%
BB - 18%
MCT Oil
I have two ideas on why this happened.
1. My previous brews were at either 100 mg/mL or 200mg/mL Could the concertation for this be too high for my filter? I know I am brewing a relatively low concentration Test, but my previous brews did not have this issue.
2. I received all my raws from PPL besides this Test E. I got this from QSC's domestic warehouse. Do you think there is an issue with QSC's product?
Any ideas would be great.
I did a 250mg/mL brew today of Test E and ran into some issues filtering. I use a glass vacuum filter with a .22um filter in it and a hand pump. It's worked really good for me up until today.
Today when I got the filter setup under pressure the brew did not want to pass through that filter. I pumped the pressure up to higher than normal and just got dribbles into the beaker. After of about 5mL it completely stopped.
Just to add, I can confirm that the test did fully dissolved and my brew was clear before added my carrier oil. I also did heat the brew to about 140 before filtering using a magnetic hotplate/ mixer.
Recipe
Test E - 25g
BA - 2%
BB - 18%
MCT Oil
I have two ideas on why this happened.
1. My previous brews were at either 100 mg/mL or 200mg/mL Could the concertation for this be too high for my filter? I know I am brewing a relatively low concentration Test, but my previous brews did not have this issue.
2. I received all my raws from PPL besides this Test E. I got this from QSC's domestic warehouse. Do you think there is an issue with QSC's product?
Any ideas would be great.