SynergyForge Test-Enanthate 600mg/week 5457ng/dl 9.1x

[orcaroids]

Source	SynergyForge
Test Ester Running	Enanthate
Weekly Testosterone Dose	600mg (200mg e2.33d)
Other Compounds in Cycle	Arimidex
Weekly Dose Other Compounds	0.5mg (0.5mg e7d)
Weeks Run	12
Draw Time from Last Pin	9 hours
Blood Results
Testosterone Reading	5457 ng/dl
Testosterone Multiplier	9.1x
Test Capped at 1500	No
Estradiol Reading	21 ng/dl
Liver/Lipids Elevated	No
Pre-cycle Blood Results
Testosterone Reading	734 ng/dl
Estradiol Reading	32 ng/dl
Comments	Started Adex on week 2/3rd pin

 

[orcaroids]

@CaptainAmerica Hey chief, would you please check these for approval when you get a minute?

 

[CaptainAmerica]

@CaptainAmerica Hey chief, would you please check these for approval when you get a minute?

Draw time is way off my guy. Check the wiki bloodwork section

 

[orcaroids]

Dammit, I'll get this right I swear. I got two more weeks or so on this cycle, I'll get tested 48 hours after my next pin.

 

[Luxferro]

How’s your E2 so low with such a small dose of arimidex? 0.0

 

[orcaroids]

How’s your E2 so low with such a small dose of arimidex? 0.0

I don't aromatize much, I don't think. I'm also relatively low bf%. This is my 2nd cycle. My 1st had me at 15 pg/dl of E2 on double the Adex dosage. I might just skip out AI altogether for the rest of this cycle and my next cycle and keep some Ralox on hand in case of gyno. I definitely felt some low E2 sides on my first cycle, less so on this one.

 

[Luxferro]

What low E2 sides did you experience?

 

[orcaroids]

What low E2 sides did you experience?

Biggest one was achy joints. My knees especially were constantly hurting. Also took 2 minutes before I could piss every time, and was drinking a lot more water than I usually do.